Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 Rubber Feet for Center Stand?
#27
Just thinking about this thread after I put my bike on the center stand last night when I got home to lube the chain.

One thing I do which might help is this - as I mentioned earlier, I put a rubber mat on the floor before I lift the bike onto the center stand. When I'm ready to bring it back down, as I stand on the left side of the bike, I plant one foot in front of the left edge of the center stand while I lift the bike off the stand using the rear grab rail. That helps to keep the bike from sliding.
Reply


Messages In This Thread
RE: Rubber Feet for Center Stand? - by Obleo - 04-05-2021, 10:40 PM
RE: Rubber Feet for Center Stand? - by Tev62 - 04-06-2021, 12:24 AM
RE: Rubber Feet for Center Stand? - by Dave_imp - 04-09-2021, 09:22 AM
RE: Rubber Feet for Center Stand? - by Gone in 60 - 04-20-2021, 01:38 AM
RE: Rubber Feet for Center Stand? - by Tev62 - 04-20-2021, 03:41 AM
RE: Rubber Feet for Center Stand? - by Tom_imp - 04-22-2021, 10:42 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  What does G91 stand for under the gastank cap (see pic)? bioman_imp 8 553 07-06-2022, 02:01 AM
Last Post: bioman_imp
  Need help ! Center stand installation enterlance_imp 14 818 01-08-2022, 05:25 AM
Last Post: the Ferret
  Attaching center stand Whippa_imp 9 612 12-18-2020, 06:15 AM
Last Post: Rocky_imp
  Rubber dampers for the 2017 CB1100 EX's front rotors VLJ_imp 14 1,317 06-21-2019, 11:56 PM
Last Post: 17-CB-002
  Warm feet Randy B 18 1,404 11-10-2018, 11:23 AM
Last Post: GoldOxide_imp
  Has anyone removed the rubber from their stock footpads? DoyleInMN_imp 6 345 04-26-2015, 01:31 AM
Last Post: Lord Popgun
  Shifter Question. Big Feet holy666diver_imp 5 384 04-11-2015, 10:06 AM
Last Post: aschem_imp
  Side Stand Pivot emptysea 10 521 01-24-2015, 01:51 PM
Last Post: gossman_imp
  With a Center Stand do you even need a front stand? PJV_imp 16 892 10-31-2013, 09:44 PM
Last Post: sanoke_imp
  Abba Stand Work on the CB PJV_imp 0 164 10-25-2013, 09:36 AM
Last Post: PJV_imp

Forum Jump:


Users browsing this thread: 1 Guest(s)