10-16-2015, 02:12 AM
(10-15-2015, 07:39 PM)TK LEE_imp Wrote: Hi Dave
Me and some other CB riders have same problem here.
Could you let me know the link of how to adjust TPS please?
(09-06-2015, 01:07 AM)Dave_imp Wrote: Thank you all for your replies and advice. Yes, this bike ran bad when new, but I corrected this by adjusting the throttle position sensor as recommended by another member on this site and it has run perfectly ever since. I took my bike for a ride the next morning and it ran fine - ideling smoothly at the normal RPM without stalling. I only use premium gas purchased at reputable (Texaco, 76, Chevron or Shell) gas stations, and I have not refilled the tank since the stalling situation. I have no clue what was causing the stalling, but it appears to have corrected itself. I'll report back to this link if the problem returns.
Procedure is:
-Make sure switch is set to run
-turn ignition on (but do not start)
-slowly twist throttle from fully closed to fully open twice
-turn ignition off
I wasn't having major issues like OP was but did have roughness at low RPM with small throttle inputs. This fixed my issue. It is much smoother, especially throttle rolloff at low speeds.