Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
crankshaft balancer backlash adjustment
#23
Mine has almost 11k miles. The balancer was set on 2 and you can hear it rattle, i could adjust to 5 to make it whine. 3 to 4 sounded like the sweet spot though. So i went for the "less is more" approach. I'll let it warm up from cold in the morning and then give it 20 miles to work. Too bad I am not in Texas. I'd like to hear it.
(08-27-2014, 11:16 AM)Lord Popgun_imp Wrote: Just for info. When the 13s first came out, a guy on the UK board had a bad chatter like this. The dealer apparently had to (apparently) change out the balancer. They were pretty vague about the whole thing (to the owner), but it was done under warrenty by direction of Honda. There was even a thread about adjusting the balancer and I posted the manual procedure, or most of it...

Must have been to tight from the factory based on what the FSM says.
Reply


Messages In This Thread
RE: transmission balancer backlash adjustment - by dlhmatt_imp - 08-27-2014, 11:23 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Valve Adjustment Shims dave 13 741 07-28-2026, 12:49 PM
Last Post: MagnaRider
  Valve Adjustment and Camshaft Removal dave 5 649 03-21-2026, 04:49 PM
Last Post: Cormanus
  Valve Adjustment dave 6 875 08-29-2025, 10:46 AM
Last Post: dave
  Valve Adjustment Intervals CBRider_imp 32 3,112 04-21-2025, 02:24 PM
Last Post: Jurlie_imp
  Rear Brake Pedal Adjustment Gone in 60 12 1,178 04-04-2024, 08:18 AM
Last Post: Gone in 60
  Valve Adjustment Tolerances - How Far Do You Go? dave 14 1,596 10-18-2023, 09:28 PM
Last Post: The Gecko_imp
  Should I adjust my crank balancer? DutchRutter 16 1,381 05-29-2022, 07:39 AM
Last Post: DutchRutter
  Front forks adjustment Olyrider 5 539 05-16-2022, 11:04 PM
Last Post: Sparky80_imp
  Mirror Adjustment Question deltamark 14 1,288 03-12-2022, 03:53 AM
Last Post: Charlie Bravo_imp
  Does my 2013 CB100 REALLY have no clutch adjustment? Olyrider 13 1,184 09-23-2021, 02:41 AM
Last Post: pekingduck

Forum Jump:


Users browsing this thread: 1 Guest(s)