06-17-2016, 09:43 AM
I moved mine back to where the reflectors around the plate were. I used info from something vfrpaul98 wrote about the connectors a while back. I think Kennyw did a good job explaining his move.
(Now if someone would come up with a short plug and play Male - Female cable extender you wouldn't have to mess with the wiring.
http://www.cycleterminal.com/050-connectors.html
2 pin HC .050 Turn Signal Connector
needed for rear signals only on 2013 cb1100
order 2 male and 2 female connectors and you can make your own extension length.no minimum order.
just a thought.
Paul.)
Hope this helps.
Jon Z
(Now if someone would come up with a short plug and play Male - Female cable extender you wouldn't have to mess with the wiring.
http://www.cycleterminal.com/050-connectors.html
2 pin HC .050 Turn Signal Connector
needed for rear signals only on 2013 cb1100
order 2 male and 2 female connectors and you can make your own extension length.no minimum order.
just a thought.
Paul.)
Hope this helps.
Jon Z