03-24-2016, 12:48 AM
(03-23-2016, 09:56 AM)Jim21680_imp Wrote: Hmm...if I'm imagining this right, you're thinking of rotating the cooler out into a vertical position (out away from the normal frame-mounted angle)?
I think that would undoubtably draw more attention to the cooler instead of the engine, as if something was broken off or bent, etc.
It could probably be mounted to the lower fork tubes, either in front or behind the stanchions. I don't think you'll do better than that.
not rotating, not moving, just changing the angle, away from the frame at the bottom of the cooler stiil at the frame at the top of the cooler.
