03-23-2016, 09:56 AM
Hmm...if I'm imagining this right, you're thinking of rotating the cooler out into a vertical position (out away from the normal frame-mounted angle)?
I think that would undoubtably draw more attention to the cooler instead of the engine, as if something was broken off or bent, etc.
It could probably be mounted to the lower fork tubes, either in front or behind the stanchions. I don't think you'll do better than that.
I think that would undoubtably draw more attention to the cooler instead of the engine, as if something was broken off or bent, etc.
It could probably be mounted to the lower fork tubes, either in front or behind the stanchions. I don't think you'll do better than that.
