03-27-2017, 01:56 AM
(03-27-2017, 01:50 AM)holy666diver_imp Wrote: So i did my oil and chain this week end. I needed to tighten up my slack so I did as I usually do.
Loosen axle nut
adjust left and right adjusters one at a time equal truns.
Check slack.
I was at an inch on the slack and at 3 1/2 notches on each side of the chain adjuster.
I then tightened the axle nut and torqued to 69 lb ft.
I noticed the right side chain adjust screw can be loosened by hand after the axle was locked in place. It doesn't effect anything since the axle is locked but is it normal to have that adjuster be able to rotate by turning with your finger? left side with the chain on it is tight
No. I'd say, the right end of the axle moved a little bit back by tightening the axle nut. That released the right chain adjuster.