05-29-2017, 09:45 AM
(05-29-2017, 06:39 AM)Aka Tsubasa_imp Wrote: You are way over thinking this. The bearings were already pushed by the inner races, if at all, when the wheel was installed with the spacers on the wrong sides. I honestly can not see how the bearings would have been pushed in the first place. Nothing was holding the wheel side to side. Just swap the spacers so they are correct and install the wheel per the factory manual. It will be fine.
Tried that. Everything is shifted so that when I tighten the axle nut there is now a gap with the axle showing between the left spacer and the fork and the left brake caliper is overlapping the fork bosses at least 1/8 inch (can't get the left brake caliper on).