08-17-2017, 03:54 AM
To tap the brake light wire? I de-pinned the connector and soldered the wire to it and then re-pinned it into the connector.
However, VERY LITTLE solder was used and the Givi wire is really small. Even with good solder skills, it was a job getting the pin back in. It did seat though.
I have a connector kit for our connectors and if I had to do it again I would crimp the two wires on a new pin. There are a couple ways I might would do it different without tapping or cutting the harness.
Realistically, you will either be tapping the wire or maybe cutting it and adding a bullet connector or crimp splice. Just think about it before cutting stuff. Make sure you have space and no chaffing when you get done.
However, VERY LITTLE solder was used and the Givi wire is really small. Even with good solder skills, it was a job getting the pin back in. It did seat though.
I have a connector kit for our connectors and if I had to do it again I would crimp the two wires on a new pin. There are a couple ways I might would do it different without tapping or cutting the harness.
Realistically, you will either be tapping the wire or maybe cutting it and adding a bullet connector or crimp splice. Just think about it before cutting stuff. Make sure you have space and no chaffing when you get done.