Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Deciding 37 vs 35 tooth rear sprocket on 2013, 19 on Front is correct
#14
rbike, thanks for posting this topic. I did find it surprising that the 2014 was geared so tall to require only 3300 at 70mph, but I also remembered the roll-on torque was gone too. Something strange going on......I'll check the numbers again. Primary ratio wasn't changed.

Anyway, after doing my 19/37 conversion, swingarm slider clearance appears the same. Added a little with the 19 front, took a little with the 37 rear. Compressing the rear shocks or putting on slightly longer shocks would cause closer contact than this mod would.

Please publish 7th Gear's contact info, as he has moved.
Reply


Messages In This Thread
RE: Deciding 37 vs 35 tooth rear sprocket on 2013, 19 on Front is correct - by pekingduck_imp - 11-10-2015, 01:16 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Rear indicator (Turn signal) relocation bracket 2013 model AndyBeeMD 15 1,249 08-16-2025, 05:01 PM
Last Post: bflint
  Chain and Sprocket Options? Yata-Garasu_imp 22 1,664 12-23-2024, 04:47 AM
Last Post: pdedse
  Chain or sprocket problem ? The Gecko_imp 14 1,044 07-30-2024, 10:05 AM
Last Post: Lord Popgun
  Rear only tire on the front? mattmcuomo@yahoo.com 5 452 10-09-2023, 06:05 AM
Last Post: mattmcuomo@yahoo.com
  Front sprocket bolt cant be moved misterprofessionality 55 3,661 03-13-2023, 12:18 PM
Last Post: misterprofessionality
  What is the Correct Chain Size for a 2014 Model? chync_imp 12 962 02-28-2023, 01:16 AM
Last Post: Maturecheese_imp
  Front drive chain sprocket wear 1970Cadillac_imp 15 952 11-29-2022, 07:49 AM
Last Post: dave
  How to remove 2013 Rear ABS/Speed sensor danieljrmurray_imp 16 1,106 06-03-2022, 01:16 PM
Last Post: pekingduck
  VIBRATION - deciding too much; and living with it. JustPassinThru_imp 132 8,320 05-31-2022, 07:47 AM
Last Post: GoldOxide_imp
  17 tooth CS sprocket install, comments. Bike #12_imp 11 731 01-03-2022, 08:30 AM
Last Post: misterprofessionality

Forum Jump:


Users browsing this thread: 1 Guest(s)