Woodcraft clip on adapter - anyone interested?

[nikechosun_imp]

Hello

I use the Google translator.
My question may be difficult to understand.

1. Is it possible to manufacture? As shown in the picture

- It seems to be able to use the clip-on angle adjustable.
- 1-3 inches mounted upside down it seems to be available Riser height low.

[Ferrealls_imp]

Hello

I use the Google translator.
My question may be difficult to understand.

1. Is it possible to manufacture? As shown in the picture

- It seems to be able to use the clip-on angle adjustable.
- 1-3 inches mounted upside down it seems to be available Riser height low.

Welcome, nikechosun.

That's pretty easy to manufacture. It's the same basic setup as the Woodcraft adapter. I'm thinking of having something similar built by my machine shop. Angle adjustment would be easy with that setup. I'd be a little hesitant to turn those upside down without a keeper ring or lip to keep the clip-ons secure.

[nikechosun_imp]

Thank you.
I live in South Korea.
You are interested in Wood Craft Clip on adapter.
South Korea is also a lot of CB1100 riders interested.
CB11 is a fuel tank interference issues clip-on installation is not possible.
That will enable the adapter will use it.



1.1 - 41mm fork on the top of the Adaptor to extend capabilities (such as photos).
1.2 - All clip-on Equipped seems possible.
1.3 - It will be the height / angle is set. clip-on mounting upside down.

2.1 - Production costs and terms
2.2 - What materials do you use? (Duralumin or Aluminum?)
2.3 -


ps : I will look forward to wonderful results.