+- The CB1100 Community Forum (https://cb1100forum.net/forum)
+-- Forum: Honda CB1100 Discussions (https://cb1100forum.net/forum/forumdisplay.php?fid=5)
+--- Forum: Accessories/Modifications (https://cb1100forum.net/forum/forumdisplay.php?fid=8)
+--- Thread: Spools for pit stand. (/showthread.php?tid=8229)
Pages:
1
2
RE: Spools for pit stand. - mvk24_imp - 03-21-2021
(03-21-2021, 07:52 AM)Houtman_imp Wrote: Depending on the type of spool YOU bought I used tapered bolts with alan type head so they are flush with the spool . I think that I bought them from Bolt Depot but not 100 % certain.Sounds like thats the plan then, I like those vortex ones cause they're American made.
Sent from my SM-G965U1 using Tapatalk
RE: Spools for pit stand. - Charlie Bravo_imp - 03-25-2021
I like a center stand on a streetbike; you never know when your gonna need to stand the bike straight up. I gas up sitting on the bike and get it full. My NTM Suzi doesn't have one, and it's annoying so I plan on getting one from ebay.
RE: Spools for pit stand. - Obleo - 03-25-2021
If the axel is hollow, you can run a threaded rod cut to the right length with washers and nuts set at the correct spacing. Tec products in England makes them for Triumphs . I fabricated my own as described above. Tech’s are permanently mounted but I use them for cleaning the chain and rear wheel on a 2020 Triumph Speedmaster with no center stand , remove them when finished.