ABS Light Flashing on 2017EX

[Exbex1_imp]

I figured. Will disconnecting battery reset the computer?

[Lord Popgun]

I figured. Will disconnecting battery reset the computer?

Not sure. I'd have to do some reading in the service manual. However, if the pulses aren't consistent the ABS will call a fault, or in one members case the speedometer was wonky (slightly bent rear ring).

Once the ring is replaced and the gap correct, the fault will most likely clear itself.

[Exbex1_imp]

Thank you! I’ll get back to you. The part should be here Friday. I'll try not to boger it up again.
Tom

[Exbex1_imp]

I figured. Will disconnecting battery reset the computer?

Not sure. I'd have to do some reading in the service manual. However, if the pulses aren't consistent the ABS will call a fault, or in one members case the speedometer was wonky (slightly bent rear ring).

Once the ring is replaced and the gap correct, the fault will most likely clear itself.

Not sure. I'd have to do some reading in the service manual. However, if the pulses aren't consistent the ABS will call a fault, or in one members case the speedometer was wonky (slightly bent rear ring).

Once the ring is replaced and the gap correct, the fault will most likely clear itself.
You are correct sir! 30 minutes, new front pulser ring, and no more flashy flashy!
Life is good again!
Thanks.

[iamheero_imp]

Just as an update on my own situation. I cleaned my calipers thoroughly and since switching to the EBC HH sintered front pads, using a liberal amount of brake-quiet (basically just silicone lube AFAIK?) on the pads I haven't had any issues with the ABS. I still have some front brake squealing, but it's not leading to failure in the ABS at least. I did 20,000 miles on the CB last year so it's working out, whatever problems I had for a bit when the bike was new seem to have just disappeared, I didn't replace anything.

[Lord Popgun]

Good work Exbex1! Glad you got it worked out.