Posts: 23
Threads: 6
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Nov 2018
Hello
I started suffering shoulder and throttle hand discomfort on long rides so I installed Bar Risers Voight MT and Kaoko Throttle Lock. Initial results are positive and now looking forward to end of Pandemic so I can test on long ride.
Posts: 8,026
Threads: 21
Likes Received: 180 in 103 posts
Likes Given: 121
Joined: Apr 2025
Mitch, you're going to get asked, so I'll do it
Did you have to get any longer cables or hoses?
Posts: 463
Threads: 9
Likes Received: 59 in 23 posts
Likes Given: 38
Joined: Apr 2025
I have both a throttle lock as well as a "cramp buster". I find that the cramp buster is worth it's weight in gold! You use the heel of your hand to control speed, and can just rest your throttle fingers on the brake lever for a brief respite. Worth a try for around $15 -$20. The throttle lock works fine on flat road, but here in the hills it's less useful.
Posts: 23
Threads: 6
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Nov 2018
Hello Again,
No issues with length of cables or hoses.
Mitch
Posts: 160
Threads: 7
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Mar 2015
I’ll second the crampbuster and throttle lock combo. I like having both options available.
Posts: 6,964
Threads: 93
Likes Received: 417 in 234 posts
Likes Given: 826
Joined: Apr 2025
Had Kaoko throttle lock on my '13 model. Did not wish to transfer to the '14.
IMHO, the most simple device is a better option, at least for me...unless you have OEM
Posts: 1,325
Threads: 33
Likes Received: 91 in 34 posts
Likes Given: 39
Joined: Apr 2025
I have the Voight risers on one of my other bikes, excellent quality German product. They have a good selection of risers for the CB1100EX/RS (SC65 & SC78), 20, 25 & 30mm risers only and a 30mm rise/21mm closer set too.
Posts: 1,360
Threads: 10
Likes Received: 123 in 71 posts
Likes Given: 316
Joined: Apr 2025
Awhile back I ordered a set of set-back/risers that look like the Voigt, but were a generic brand on Amazon. I returned them because, when tightened down there was a gap between top and bottom. They were very nicely made and looked good otherwise. Very small gap, but it worried me. Is that gap anything to be concerned about?
Posts: 1,325
Threads: 33
Likes Received: 91 in 34 posts
Likes Given: 39
Joined: Apr 2025
(02-10-2022, 03:52 AM)Nachodaddy_imp Wrote: Awhile back I ordered a set of set-back/risers that look like the Voigt, but were a generic brand on Amazon. I returned them because, when tightened down there was a gap between top and bottom. They were very nicely made and looked good otherwise. Very small gap, but it worried me. Is that gap anything to be concerned about?
Possibly not. Some designs have a gap at the front and rear and some have no gap at the front and an open gap at the rear as in my example shown here. As long as you follow given torque settings for your type all should be well.
Posts: 1,360
Threads: 10
Likes Received: 123 in 71 posts
Likes Given: 316
Joined: Apr 2025
