Anybody running the Samurider low bars?

[Lord Popgun]

And for those who can't drill into a tube, Webike has a handlebar drilling guide that clamps on the bar. Is about 25 bucks I believe it was.

[avsbezzy_imp]

yep, same, they are about 1.5" lower and 1" narrower, I prefer them over stock. did someone mention that the holes for the controls don't line up on the 2014's?

I'm curious about this, too. Samurider says "Fits: 2013 CB1100 *drilling is needed for the 2014 CB1100"

Have any of you installed these on the 2014 and, if so, what kind of drilling was actually required?

I'm curious about this, too. Samurider says "Fits: 2013 CB1100 *drilling is needed for the 2014 CB1100"

Have any of you installed these on the 2014 and, if so, what kind of drilling was actually required?
Drilling required on 14' dlx . Make sure you measure
twice...
The brake hoses are a little under stress because of the
Bend necessary. Throttle cable is tight on right hand
U-turns. Throttle cables rerouted with comet 1.
Position is great.
If you have Dlx big tank b we careful not to damage your tank with the control switches. Push the bars forward before final adjustment.

[dancinkozmo_imp]

anyone have pics of these bars installed on their machines ??

[Griso Guy_imp]

Bars are back ordered as per Samurider's email to me on Monday.

[beardyweirdy@me.com_imp]

Defo recommend the type 2 bars, front end needed more weight on it and these helped. Look better and more comfy too...

I'd make the effort to drill them. If you grind off the blobs you'll regret it.

Kev