Anybody running the Samurider low bars?

[Griso Guy_imp]

I like the Road Comet on my 2014 DLX. But I think I would like to install the low bars from Samurider. Anyone have any input on these?

[Capo]

I have the Honda Type 2 bars, bought from Samurider. Best single mod I've made. More comfortable and better front end feel. Three thumbs up.

[Griso Guy_imp]

I have the Honda Type 2 bars, bought from Samurider. Best single mod I've made. More comfortable and better front end feel. Three thumbs up.

Thanks Capo, I am ordering a set.

[HikerToo_imp]

yep, same, they are about 1.5" lower and 1" narrower, I prefer them over stock. did someone mention that the holes for the controls don't line up on the 2014's?

[Cormanus]

I have the Honda Type 2 bars, bought from Samurider. Best single mod I've made. More comfortable and better front end feel. Three thumbs up.

Where did you get the third thumb?

[Capo]

[/quote]

Where did you get the third thumb?
[/quote]

It's a long story, Cormanus, and it's not That kind of forum....

[Cormanus]

Where did you get the third thumb?
[/quote]

It's a long story, Cormanus, and it's not That kind of forum....
[/quote]

LOL

[skimhitz_imp]

I have the Honda type 2 bars. I found the fact that they are narrower to be a bit strange at first, but overall I love them. I found the older bars forced me to sit too upright, which is hard on my back.

[Setchman_imp]

yep, same, they are about 1.5" lower and 1" narrower, I prefer them over stock. did someone mention that the holes for the controls don't line up on the 2014's?

I'm curious about this, too. Samurider says "Fits: 2013 CB1100 *drilling is needed for the 2014 CB1100"

Have any of you installed these on the 2014 and, if so, what kind of drilling was actually required?

[rboe]

Some bits that go on the handlebar (master cylinder, mirror and lever holders) have indexing pins. These pins need matching holes. On my XR650 I think I ground the pins off.