Posts: 137
Threads: 24
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2016
So after adjusting the chain slack on my CB today I decided to clean up the rear end of the fender....all because while adjusting the chain I hit the license plate bracket twice with my forehead, I decided to remove the bracket and this is what I ended with.
![[Image: 73343224fb9d98cdc89abbaaf53f40ef.jpg]](https://cb1100forum.net/forum/uploads/imp/201703/73343224fb9d98cdc89abbaaf53f40ef.jpg)
Hope y'all like it!
Cheers
JD
Sent from my SM-N910T using Tapatalk
Posts: 363
Threads: 11
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2015
Looks great JD!
Sent from my iPhone using Tapatalk
Posts: 98
Threads: 4
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Dec 2016
where's the before photo? LOL! very nice!
Posts: 23,428
Threads: 697
Likes Received: 511 in 233 posts
Likes Given: 666
Joined: Apr 2025
Good job!
Looks amazingly like the Chip Beck Lic plate mod from June of 2013 lol.
http://cb1100forum.com/forum/showthread....=Chip+Beck
Posts: 363
Threads: 11
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2015
You're lucky JD that the new bolt locations frame nicely around your state's initials!
Posts: 137
Threads: 24
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Aug 2016
(03-21-2017, 01:53 AM)The ferret_imp Wrote: Good job!
Looks amazingly like the Chip Beck Lic plate mod from June of 2013 lol.
http://cb1100forum.com/forum/showthread....=Chip+Beck
LOL in 2013 I was living in a communist country....and his is actually better than mine ...I just drilled holes on the license plate Ha!
Sent from my SM-N910T using Tapatalk
(03-21-2017, 03:19 AM)c-breezy_imp Wrote: You're lucky JD that the new bolt locations frame nicely around your state's initials!