The CB1100 Community Forum

So after adjusting the chain slack on my CB today I decided to clean up the rear end of the fender....all because while adjusting the chain I hit the license plate bracket twice with my forehead, I decided to remove the bracket and this is what I ended with.


Hope y'all like it!

Cheers
JD

Sent from my SM-N910T using Tapatalk

Looks great JD!


Sent from my iPhone using Tapatalk

where's the before photo? LOL! very nice!

Good job!

Looks amazingly like the Chip Beck Lic plate mod from June of 2013 lol.

http://cb1100forum.com/forum/showthread....=Chip+Beck

You're lucky JD that the new bolt locations frame nicely around your state's initials!

(03-21-2017, 01:53 AM)The ferret_imp Wrote: [ -> ]Good job!

Looks amazingly like the Chip Beck Lic plate mod from June of 2013 lol.

http://cb1100forum.com/forum/showthread....=Chip+Beck

LOL in 2013 I was living in a communist country....and his is actually better than mine ...I just drilled holes on the license plate Ha!

Sent from my SM-N910T using Tapatalk

(03-21-2017, 03:19 AM)c-breezy_imp Wrote: [ -> ]You're lucky JD that the new bolt locations frame nicely around your state's initials!