Buying Parts - Had a spill

[mvk24_imp]

Here is an update on my current parts list that I'll have to replace. The biggest ones are the instrument cluster and the headlight. I'm ok with going aftermarket, moreso with the headlight as I would like a bit of an upgrade on that. Any recommendations on speedometer? Seems like going OEM would be roughly $1200.

Other than those, here is the below..
-Rear Swingarm adjuster
-Foot steps
-Left Crankcase Cover
-Handlebar/levers
-Turn Signals
-Mirrors

Overall, not too bad and maybe a good time to make some small changes that I've been looking at. Biggest question comes into the speedo. When looking online, when sites say they are compatible. What should I look out for? I imagine they aren't necessarily plug-n-play, but that's just an assumption. Again, appreciate all the help from everyone!

What exactly is wrong with the speedo? When I had a low speed fall.

I scratched my headlight, turn signals, bent the Assy that hold the gauges (it wasnt centered around the key/ignition), and scratched the covers on the back of the speedo/tach. I also had a little road rash on the right side cover.

I was able to get a used headlight and bucket from ebay that I didnt even end up needing cause I could live with the small scratch on my headlight ring. I also got the right side cover and gasket from ebay. Brand new OEM for like half the price

I got the Assy for the gauges and covers for the speedo/tach/cluster from Bikebandit.

The scratches on the turn signal wasn't a big deal and left it and I just recently upgraded to micro LED turn signals from and back. They cost me 10$ on ebay I believe and look amazing. Much much slimmer than the stock ones and just as bright.

2014 CB1100, 1981 KZ440 LTD, 1993 Yamaha XJ600 Seca, 1994 Yamaha XJ600 Seca