my new pr3 has a flat spot

[max]

Thanks Sparky, that's good info, i finally found some in this small island and here it is;



Same idea, seen it in tire workshops and now i know why the professionals uses it.
Mix with water and apply in the working area, job's a good'n.

Here's a shot of the tire going off and on the bike with the balancing in between;

https://www.youtube.com/watch?v=uEkR-vhL7xM





The trick is to rotate the rod so the inner races move and get rid of the friction, it also checks if the bearings are in good condition ( should move smoothly )

Thanks for all the replies