08-06-2022, 09:27 AM
Very clear picture Mixagon, seems the big nut's function is to adjust the trigger point of the switch and it has run out of room.
Looks as if the left nut is part of the u shaped connector, the middle is the locknut for same and the right hand one is for switch adjustment timing.
Also from the placement of the rivets it looks like the switch is a " microswitch " and has limited travel hence the separate adjustment nut against the tab.
Could be to remove it and replace it with some washers or plastic hose to get the switch to operate at the right time or get what's called a "half nut" which is half the with of a standard one?
Looks as if the left nut is part of the u shaped connector, the middle is the locknut for same and the right hand one is for switch adjustment timing.
Also from the placement of the rivets it looks like the switch is a " microswitch " and has limited travel hence the separate adjustment nut against the tab.
Could be to remove it and replace it with some washers or plastic hose to get the switch to operate at the right time or get what's called a "half nut" which is half the with of a standard one?