08-01-2022, 09:25 PM
From a post I made a LONG time ago:
From the manual:
Loosen the push rod joint nut and turn the push rod until the correct pedal height is obtained.
If the brake pedal is adjusted to the lower position, make sure the clearance between the lower end of the push rod and the brake pedal does not fall below 1mm.
If the brake pedal is adjusted to the higher position, make sure the lower end of the push rod is visible inside the joint.
All that from the manual means the threaded shaft, or rod, needs to have some threads showing inside the linkage piece, or at least 1mm clearance with the pedal. Realize there are two nuts, the lock nut, and at the top of the shaft by the rubber boot, a nut you turn to adjust the shaft length.
From the manual:
Loosen the push rod joint nut and turn the push rod until the correct pedal height is obtained.
If the brake pedal is adjusted to the lower position, make sure the clearance between the lower end of the push rod and the brake pedal does not fall below 1mm.
If the brake pedal is adjusted to the higher position, make sure the lower end of the push rod is visible inside the joint.
All that from the manual means the threaded shaft, or rod, needs to have some threads showing inside the linkage piece, or at least 1mm clearance with the pedal. Realize there are two nuts, the lock nut, and at the top of the shaft by the rubber boot, a nut you turn to adjust the shaft length.