Bar risers

[kzoorue_imp]

So..I too purchased and installed bar risers
(Rox Speed FX Elite Series). Since the front clutch cable was at an angle, I loosened the nut for less pull/more play. Now, my clutch doesn't work. How do I solve this?

Which nut?

Clutch is hydraulic. If you have loosened the hydraulic line, you'll need to make it tight again and bleed the system.

Make sure it's not leaking: it's a nasty and corrosive fluid.

Which nut?

Clutch is hydraulic. If you have loosened the hydraulic line, you'll need to make it tight again and bleed the system.

Make sure it's not leaking: it's a nasty and corrosive fluid.
So, yes, it was the hydraulic line, I believe. It was super tight, but only leaked a very small amount... I played around with the clutch lever attachments, and loosened/re-tightened the line, and now the clutch adjustment is fine (works). I have never "bled the system". Wondering:

1. Since very little fluid came out do I need to do this?
2. If I need to do this, any videos you might recommend?

Thanks!