02-21-2023, 05:30 AM
Best practices for wiring when replacing lighting?
I have a damaged tail light and turn signal ready to replace. It appears there are no connectors at these ends.
I suppose I can solder the signal connection, but what about the tail light?
One thread I found discussed removing the fender and accessing the wiring harness under the battery box. Is there a better way?
Thanks!
I have a damaged tail light and turn signal ready to replace. It appears there are no connectors at these ends.
I suppose I can solder the signal connection, but what about the tail light?
One thread I found discussed removing the fender and accessing the wiring harness under the battery box. Is there a better way?
Thanks!
