06-03-2024, 06:46 AM
I had saved this procedure from an old post.
Honda CB1100 High Idle Problem
* Warm up the bike to get normal operating temp and idling
* Ignition OFF and remove the key from the ignition switch
* Disconnect both battery cables from the battery terminals, the negative cable first
* Cover both battery terminals with a plastic bag/rag to prevent accidental cable to terminal reattachment
* Join both cables (- &+) together for about 10 minutes. If the battery cables are too short, jumper wire can be used
* Reconnect both cables back to the battery terminals, the positive cable first, then the negative.
* Ignition ON, wait until meters sweeping is completed 2-3 sec, start your bike and observe idling.....
Honda CB1100 High Idle Problem
* Warm up the bike to get normal operating temp and idling
* Ignition OFF and remove the key from the ignition switch
* Disconnect both battery cables from the battery terminals, the negative cable first
* Cover both battery terminals with a plastic bag/rag to prevent accidental cable to terminal reattachment
* Join both cables (- &+) together for about 10 minutes. If the battery cables are too short, jumper wire can be used
* Reconnect both cables back to the battery terminals, the positive cable first, then the negative.
* Ignition ON, wait until meters sweeping is completed 2-3 sec, start your bike and observe idling.....