08-29-2013, 10:41 PM
(08-06-2013 12:33 PM)
lola Wrote: Hello all! Planning on removing the front forks for service and a posible powdercoat but don't quite know what is available out there as far as front stands go... I noticed there are two reference points under the oil pan, are they Jack Points to raise the front of our bikes? just curious to what you fellas have done.....
Thanks!
Stretch Wrote:
It happened I already had a Pitbull stand I'd bought for a Yamaha FZR400. It fit my FZ8 and the pin also fit the CB1100. Didn't even have to remove the horns. The steering stem is taper so the pin does not go all the way in but goes in plenty far enough. No problems at all.
The pin that worked for Stretch in this thread:
http://cb1100forum.com/forum/showthread....ight=stand
was the F0001-050R.
Pitbull doesn't know for sure yet. If I have any trouble with that pin George Hoffman asked to send demensions and sizes. For me that's all happening this weekend.
lola Wrote: Hello all! Planning on removing the front forks for service and a posible powdercoat but don't quite know what is available out there as far as front stands go... I noticed there are two reference points under the oil pan, are they Jack Points to raise the front of our bikes? just curious to what you fellas have done.....
Thanks!
Stretch Wrote:
It happened I already had a Pitbull stand I'd bought for a Yamaha FZR400. It fit my FZ8 and the pin also fit the CB1100. Didn't even have to remove the horns. The steering stem is taper so the pin does not go all the way in but goes in plenty far enough. No problems at all.
The pin that worked for Stretch in this thread:
http://cb1100forum.com/forum/showthread....ight=stand
was the F0001-050R.
Pitbull doesn't know for sure yet. If I have any trouble with that pin George Hoffman asked to send demensions and sizes. For me that's all happening this weekend.