The CB1100 Community Forum › Honda CB1100 Discussions › General Discussion v
Torque specs for Engine Gaurds

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Torque specs for Engine Gaurds
CIP57_imp Offline
Road Warrior
Posts: 1,229
Threads: 68
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Apr 2013
#3
03-18-2015, 08:00 AM
(03-17-2015, 11:15 PM)metalmaven_imp Wrote: I noticed that on the 2014 CB1100 that the engine gaurds that you can buy use some of the Motor mount bolts or locations.

Do these need to be re-torque'd if you add engine gaurds?

What is the proper torque?

Front engine bracket nut 36 lbf-ft
Front Engine Hanger nut ( if used ) 44 lbf-ft

Bracket nuts are the two on the frame ( Black)
Hanger Nut is to the rear of them
Find
Reply


Messages In This Thread
RE: Torque specs for Engine Gaurds - by CIP57_imp - 03-18-2015, 08:00 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Stock handle bar specs mvk24_imp 6 643 07-06-2023, 09:22 AM
Last Post: mvk24_imp
  Oil Filter Torque ohiorider_imp 11 744 11-18-2017, 03:58 AM
Last Post: SportsterDoc
  Rear axle torque question. jdvalero_imp 10 1,005 03-21-2017, 09:29 PM
Last Post: jimgl3_imp
  Euro ergo specs? jimigalahad_imp 5 500 04-22-2015, 09:08 PM
Last Post: JF Coastal_imp
  Torque Wrenches Chapomis_imp 7 488 03-26-2015, 06:38 AM
Last Post: Chapomis_imp
  Chip Beck Explains HP vs. Torque for Mr. Ferret ChipBeck_imp 36 2,630 03-20-2015, 02:56 AM
Last Post: thessler3_imp
  Horsepower vs. Torque ? Rebel73_imp 47 3,684 03-16-2015, 10:49 AM
Last Post: thessler3_imp

Forum Jump:


Users browsing this thread: 1 Guest(s)