05-31-2016, 10:41 PM
I just bought the same lift and ran into the same problems as you. I welded up a frame using 1 x 1 square tube and bolted a 1 x 8 board on top. I welded a 1" flat to the side of the frame that hooks to the lip on the lift (the 1" flat bent into a U).
I have just rode the bike on the lift using my new "sideboards" once and it felt a lot better. I'm sure it will get better with a little practice. Will have the neighbor come over and spot me for a few more practice runs.
I also got rid of the wheel chock that came with the lift and bolted Harbor Freights motorcycle wheel chock (about $50) in its place. I took the capturing device off the new chock as it was awkward to back the bike out of.
Put some eye bolts further forward to pull the wheel with tie down straps into the chock.
I have pictures I can email but I cant post them.
Mike
I have just rode the bike on the lift using my new "sideboards" once and it felt a lot better. I'm sure it will get better with a little practice. Will have the neighbor come over and spot me for a few more practice runs.
I also got rid of the wheel chock that came with the lift and bolted Harbor Freights motorcycle wheel chock (about $50) in its place. I took the capturing device off the new chock as it was awkward to back the bike out of.
Put some eye bolts further forward to pull the wheel with tie down straps into the chock.
I have pictures I can email but I cant post them.
Mike