05-04-2015, 06:52 AM
(05-04-2015, 06:49 AM)EmptySea_imp Wrote:(05-04-2015, 06:24 AM)metalmaven_imp Wrote:(05-04-2015, 06:19 AM)EmptySea_imp Wrote: OK So, I had already fabricated the aluminum plate, per ChipBeck's original plan, but I could not find the right mounting bolts and nuts. Any chance that I could purchase just the nuts, bolts, and washers you, metalmaven? As it stands, my plate is slightly bent due to the round headed bolts and the plastic frame bolts look like garbage. Let me know.
Are you talking about the 2 bolts that mount the plate to the fender?
Are you talking about the 2 bolts that mount the plate to the fender?
Yes, and the bolts for mounting the frame to the license plate.
Are you talking about the 2 bolts that mount the plate to the fender?
Yes, and the bolts for mounting the frame to the license plate.
Ok so the 2 bolts that mount the plate to the fender use the existing locknuts and washers that came stock. I can send you the 2 countersunk screws.
I can also send you the plate screws, washers and acorn nuts. Did you only need 2 sets of screws, washers and acorn nuts for the plate itself? I usually send out 4 with my bracket because it covers the whole backside of the license plate and uses 4 screws..