01-21-2025, 12:11 AM
(01-20-2025, 09:58 AM)m in sc_imp Wrote: looks good. i would suggest a cross bar welded in at the hinged uprights since you have 4 single shear pivot points on the lower frame though. this will keep it from kicking left or right over time.
you could mig in just some square tube or brace it w gussets. will stiffen it up a LOT.
.02
Thank you for the suggestion. I was planning on doing this soon, but I am going to bolt in a gusset so I can disassemble if needed. Since this is my first one/prototype I want everything removable so I can come back to painting it when its all done and make any tweaks easier. I think I will only be able to gusset the front two pivots so I still have adequate jack clearance.