CB goes in for annual physical with pictures

[clearviewx]

Lot's of ground to cover in this post.

I think we still have a thread going about trailering a bike and tie down points and so forth. So, I loaded the bike into a small 5X8 trailer I picked up from a friend.



The ramp I picked up at Harbor Freight. I never buy anything mechanical/electrical from them but I will buy things like this. The load rating is for 1,100 pounds. However, when I rolled the CB on it for the first time there was some (in my estimation) significant flex. Afterwards I noticed a few heads off pop rivets laying on the ground.



So I fixed that:



Then I REALLY fixed it by bolting 3 boxed IRON rails underneath. Heavy as heck now but pretty solid.



Inside the trailer is a removable chock with 2X6's bolted to it to give it a wider stance for increased stability. Tie downs are anchored into metal sub frame of trailer. I move the chock between my trailers depending on what my needs are at the time.



Dropped the CB off for new plugs, valve adjustment as required , rear brake pad replacement and brake fluid flush. estimated at $600.

Middle aged Shop tech rolled bike inside the store, on the main floor and said "Never seen one of these before, this is a looker, going right in the place of honor in the middle"

Better shots of bikes they had in there from last time:











Also dropped K&H seat off at upholstery shop and waiting for them to call back on what repair costs will be on the seam that's separating.

You have any side shot of the trailer?