Ohlins Piggy-backs Installed

[Mikey350D_imp]

Actually they were $1400ish.
I looked at several other brands, but decided to go with Ohlins quality.
Shocks were built by Pro Pilot (NJ)
I was VERY Very happy with their service.
I think they had to combine parts to create these shocks.
Price was $1440.
I have the lower clevis screwed all the way in,so they are OK but almost
too long.
The lower bushing is larger (16mm) than top, So Pro Pilot had to send me new lower bushings.
Drive side fit with no problems, but I did not like grab-rail bolt clearance, so I replaced it with normal socket head bolt.
(Annodized gold bolts on order)
The brake side was a clearance problem.
I had to carve out a half-moon underneath the forward grab-rail bolt.
Just used my Dewalt grinder and it looks OK from side/above.
(Can see if you look closely at photo)
For both rails I moved then in, up and back be doing the following:
-Wallered the bolt holes using mill end bit. This moved rails up and back 1/4"
-Ground down the bolt hole shoulder where rail mates to frame tabs.
This move rail in
Lessons learned:
I should have sent vendor more measurements: Shock length and stud diameters, But Pro Pilot was great about providing correct parts.
They are still too stiff, as I don't have sag dialed in yet.
Will do ride report when I get sag, Comp and rebound dialed in.
I really didn't need all the bells and whistles (rebound), But I really like the piggy-back look.

The shocks look very nice. Being Ohlins, I'm assuming you spent $6,4899.99 on them. Per side.

Yamaha's new Bolt blobbler comes with piggyback shocks if you order the upgrade version. I wonder if they'd fit...

If the length is the same, the most you would have to do is press in new bushings.
The only clearance problems with the Ohlins is the compression knob, on top of external reservoir.
Also the back end now feels a tiny bit higher, but this may be because I don't have correct sag yet: free sag is currently 6.3mm, and this feels much too stiff.