Bar Risers

[Houtman_imp]

Nate,

To start with, I'm going to try the Free Solution...rotate the bars toward me slightly and rotate the controls on the bars an equivalent amount the opposite direction.

When doing so, I'll check on the cable slack situation (or lack thereof). If rotating doesn't help much, I'll order risers at a size comparable to the amount of cable slack. SW-Motech has risers as low as 20mm and several higher increments.

Gumby.. Switches are pinned so you wont be able to move them far without drilling new holes or grinding off locator pins

Gumby.. Switches are pinned so you wont be able to move them far without drilling new holes or grinding off locator pins I broke of by mistake the locating pin on a switch of my CB1000 and that can be a pain as the switch is now a little loose on the bar.
Ordered new switch incase.