Aluminum Bikini Cowl and Seat Trunk

[bix_imp]

SHARP!!!!!! I am gonna get that seat in the next month or so. How comfortable is it honestly?


HOw hard is the install of the aluminum bikini cowl?

Went for a longer ride today. For me the seat is quite comfortable (about the same as the stock seat which also works well for me). It is about and inch lower, which means my knees are slightly more bent. I like this position a lot, but everyone's different. (To be clear: I'm not trying to sell anyone on this seat, just sharing my experience with it).

The cowl takes a bit of test fitting once you figure out where each bracket goes. A T-shaped bracket connects to the horn assembly, and two articulated brackets connect to the bridge, fork top. The trick is to first remount the headlight using the included steel mounts (these replace the stock mounts). Then it's pretty obvious where everything goes after that. The rim of the opening on the cowl fits right into the groove around the headlight when it's positioned correctly. I noticed again on today's ride how smooth and even the air going over my shoulders feels. I still feel the air pressure, but it's not buffeting and beating my chest like it had without a cowl.

Hope this answers your questions.