Fork Boots

[White Dog_imp]

The instructions calls for tie wraps on both ends and use glue on seams. The included tie wraps are good, two different sizes for top and bottom. No glue included. I only installed them in November, so it was kind of cool out and the rubber was a little too cold. I may try some silicone in the spring.
Dino

I purchased a pair of those too. Installed them on my 2014 Standard. They look pretty good but I'm not sure how to keep the seam together. You can't tell they are split from the side view if you twist the seam inward. Let me know what you think. They are very beefy and seem excellent quality.
Dino

Ordered a pair of the quick mount gaiters from Revzilla this morning. Made by Kijima. I had some "zilla bucks" to burn so I expect them sometime next week.

Are there any instructions with them? I may be able to figure out the seam locking once I have them in my hands.

Are there any instructions with them? I may be able to figure out the seam locking once I have them in my hands.

Are there any instructions with them? I may be able to figure out the seam locking once I have them in my hands. The verbage from RevZilla says "They're split down the back, and can be slid over your fork tubes, then attached with the interlocking system." I wonder what they mean by interlocking system? No mention of glue being needed. I may have assumed one side would snap into the other. A reviewer on the ad stated they snap together, then use zip ties.