GenMar X102 Risers

[White Dog_imp]

Glad it worked out! Really good customer service too.

Just for kicks, I measured the diameter of the bolts sent with the risers and compared it to the diameter of the Honda bolts I removed to install the X102 risers (new bolts came with the risers). The Honda bolt diameter measured a consistent 12.80mm whereas the bolt head with the risers were 13.1mm. Does not sound like very much difference, but it was enough to prevent the plastic bolt head covers from seating fully. (See pic in post #3). The gap between the bolt head and the hole in which it mounts is because the bolt head hole is elongated to accommodate these risers on Suzuki cycles, as well as others. I don't like that gap, since it is just on a portion of the riser, but I guess I am picky about cosmetics.