ECU on its way to Guhl's!

[Olyrider]

No way you will be disappointed!!!


I did mine last year along with a Power Commader V. (PC V went on first.) Night & day difference with the PC V. I remember the first time I let go of the clutch lever in the parking lot. The bike leaped ahead. Totally unexpected. It was awesome!

I also put on a Yosh full exhaust because it reminded me (in pictures) of the Kerker pipes from way back when. But the sound the Yosh makes is now my favorite part of the bike. Not because it is "loud". It really isn't, but it does sound like a 4-cylinder motor in a highly-efficient state of tune now. I can ride in 2nd gear all day and never get tired of that sound. And I added an K&N air filter. And had the bike dyno-tuned. The dyno-tune produced the last little bit of throttle I wanted.

After the PC V and ECU re-flash, I had a lot of popping on de-cel. Kinda ruined the whole thing for me as it just signaled an incomplete or improper modification. Didn't quite know where to turn since I was getting conflicting messages from those that had been helping me. Then the forum came through...

The PAIR valve cutoff fixed everything immediately. Felt like my modification went from 50% successful to 100%. For free, in about ten minutes. Can't beat that!

For those that say ECU re-flashes and PC V's are a waste of money (i.e. they don't add horsepower) I strongly disagree. I ca't believe anybody that says that has ridden a re-mapped bike. I din't go into this expecting huge dyno runs. I just wanted the engine to perform in line with the quality Honda built in it. None of these changes make the motor brittle, or incubate future problems. But...it is truly a different bike now. After buying it and riding 100 miles, I thought I had made a mistake, and that the CB1100 would soon become boring. I was afraid it would get pushed further back in the shop while I rode other bikes. Now it is my go-to bike.

Headed out for a ride now.

Enjoy the transformation Rebel73!!!!!