Emgo Exhaust??

[dsinned_imp]

With respect to OEM mid pipes, is it possible there are physical size differences between 2013 and 2014 CB1100 model years or "within" each model years. I have a 2014. I presume "uscgmac" does as well, and his mid pipes is apparently incompatible with a direct slip on connection to the Emgo, with or without omitting his existing Delkevic extender pipe. I never tried a direct connection the my mid pipe, but had the same problem using my Delkevic extender pipe (with center stand bracket). The ID of Emgo's inlet is way too small to "slip on" to the end of my extender pipe. The diameters are grossly mismatched by as much as 1/4".

I'm approximating, but what is needed is a curved extender pipe about 12" long, with an appropriate welded on center stand bracket, that goes from ~1-5/8" ID at its inlet to ~1-3/4" OD at its outlet, where the inlet end is clamped on the outside and the outlet end is clamped inside the mating Emgo slip on. I'm not expert, but the tolerance on both of these end to end diameters should be +0, -1/16" to have snug slip on connections. Such a link pipe adapter "off the shelf" probably does not exist by the CB1100.