Gut Factory Muffler

[ChipBeck_imp]

The center pipe is relatively soft thin metal, I did shorten mine with a dremel...the problem is getting a long enough shaft to reach deep enough to get past that big baffle plate.

I'm assuming they don't make an extra long dremel cutter because it can't take the side loads, at least if they do I haven't seen one.

If I could get a dremel cutter 5 inches long, I could shorten the center pipe now, since nothing is flowing through it, it's kind of useless.

I have wondered about cutting the bezel hole bigger, but I need it to be a very clean even cut since it will be exposed....any suggestions on how to cut it?

I thought about grinding along a ridge, what I think really need is a big fancy laser cutter?

Offroadfx4,

What I think you really need is a Stayintune slip on and an ice cold beer!!!

Great sound, less filing!!! I also drive a Ford FX4. Cheers.

Chip