Fitting clubman bars on the CB

[Aussieflyer]

my clubman bars are a real tight fit, meaning that the switch block only clears the tank by 1/8" on full lock whilst the clutch banjo bolt (holds the clutch line to the master cylinder) is touching the instrument housing - I put a thin piece of rubber between them to prevent any damage. It took a bit of time to get the positioning right to feel comfortable and not touch the tank. Ideally the bars would be about an inch wider and none of these issues would exist. Below is a diagram showing the measurements of my bars if that helps you source something in the US.

[url=http://s121.photobucket.com/user/aussieflyer1100/media/Motorcycles/CB1100%20Cafe%20Racer%20Build/Third_Gear_Clubman_Specs__16771_zoom_zpscb26431b.jpg.html]