EOT meter for OEM oil cooler

[dsinned_imp]

Thanks Ferret. Yes, I am quite pleased with how this project finally turned out.

I forgot to mention one other thing . . . I lowered the fan slightly to be flush with the bottom of the EOC by offsetting it downward about half an inch from the EOC's center mounting point. I did this to prevent any fingers from accidentally touching the blades while the fan is operating. The rotational speed is over 6000 rpm!

The fan has a finger guard already, on the front side only. However, without this mounting offset, there was too much of an accessible opening at the back side above the top of the cooler. This potential safety hazard has now been avoided because access to the blades is no longer possible. The gap is greatly reduced, plus the oil return pipe along the top of the cooler blocks what little opening remains.