arrow slip on

[lynnster_imp]

Here is a thread that talks a little about your problem. Maybe reading all 2 pages and looking at the part breakout on page 2 will help. Most of the thread is about what turned out to be improper mounting though.

But you may the the gasket wrong or something.

http://cb1100forum.com/forum/showthread....ight=Arrow

Ok, I just looked in the service manual and for the stock muffler it says,
Install gasket on the exhaust pipe (thats the silver 'rubber' thing)
Install muffler into the exhaust pipe

So, your new Arrow should go into the exhaust pipe. I would imagine some force might be needed to seat it as it is new and never been compressed.

Thank you so much for the link from other members, I found the problem and the solution from the posts. Just like the other member, I mounted the back part of the slip on to the outside of the screw/bolt on the back part of the bike, so it made the muffler short by about 1/2 inch. I remounted it with the back mount of the slipon on the inside and it now fits.
Wow, you guys are the best!