Emgo fairing

[0011bc_imp]

Kenny, thanks again, I'll measure closely. Another friendly chap on the forum here named captwb sent me some good go-by's too.

Quick question, what is the material you put in between your gauges and the windshield? It looks like some foam tape of some type?

I didn't trim at the horns. It does touch though. I should double check and see if it should be trimmed.

For the turn signals, I put the center of the half circle at 1.5 inches below the centerline of the mounting slot. This ended up being too high and I had to expand the notch. It was probably closer to 1.75 inches as seen in picture 7.

you dont need to trim at the horns. just loosen the nut, take a channel locks and bend the horn bracket tab down (not the whole bracket, but just the part that doesnt allow the horns to be rotated down, you'll see) then rotate the horns down a bit and tighten the nut back down.
this tab




not sure if you can tell but my horns are closer together than yours...


and now that im looking at it i need to adjust mine because theyre a bit crooked....