Emgo fairing

[0011bc_imp]

i like the viper i installed, used stock bucket hardware

Where did you happen to find that?? It looks really good. How is it at highway speeds?

Where did you happen to find that?? It looks really good. How is it at highway speeds?
I found it at my local shop

http://milwaukeecycle.com/ but you can get them anywhere

Someone asked about the shield hitting the gauges...
I took my Drimmel and cut off a chunk of the plastic at the bottom where it contacts the horns and made enough room to tilt the fairing forward so that it sits about two inches above the gauges. Since the only mounting points are the headlight mounting screws, you can just pivot the whole thing forward. I didn't bother making a bracket for the bottom because the mounting screws seem to hold it all stable, even at speed, but others have added something to support the bottom.

I dremeled enough out by the gauges for exact fit around the headlight bezel, I also had to notch out for the turn signals, I also used adhesive weather stripping around the dremeled parts that come into close contact to avoid wear on the gauges, and two little pieces on the brake reservoirs for the same reason.