K H tall seat from samurider

[Retsel_imp]

Looks good Retsel, I like the red stitching, it adds a nice touch.

I picked up a pre-owned K&H mid from a member here and it is an improvement. I did notice a coupla-few things on mine:
[ul] [li]the front part of the seat makes contact with the tank and the under side stitching tends to rub/wear on that section of the tank. I picked up a piece of that 3M clear tank protector that I will install at some point to protect or at least prolong the wear.
[/li][/ul] [ul] [li]also noticed during seat install you can seemingly slide the seat into the tongue slot at the front, click-lock it in place and actually miss the intended slot. The seat will fit a bit sloppy, I notice I have to apply pressure at the nose or front when sliding her in to get it in the right slot (so to speak). This of course lends itself to more of that same pressure/wear on the tank.
[/li][/ul] [ul] [li]lastly, a minor issue, but no built in convenient little area to hold your documents, registration, insurance, owners manual, etc, like the OEM.
[/li][/ul]
Congrats on the new addition, it looks like a good match.

Thanks for the tips. In a previous photo posting, by another member, it looked like there was a gap between the tank and seat. I was thankful it fit as snuggly as it does. Didn't think about the possibly of rubbing the tank. I'll put something between as well.

Haven't had any problems attaching the seat but thanks for the heads up!

Sent from my Moto G (5) Plus using Tapatalk