Attaching led strip light to running light?

[Lord Popgun]

Beast, go here for a wiring diagram: http://cb1100forum.com/forum/showthread....#pid199015

It is post 8. Click on the red here at the bottom.

Like Sportsterdoc says, the accessory connector is red and is capped. Just for info, there is another one under the tool tray in a boot on the left side of the bike. Removal of the left side panel helps with accessing it.

Anyway, remove the headlight, looking into the shell, the connector is on the left towards the bottom. It may be taped and is a 2 pin connector.

One wire is green and is ground. The other is 12v when ignition is on. But you should verify with a meter in case of a factory wiring error.

Unless you have a connector shell, pins, and the proper crimp tool for Hitachi connectors, you will have to either tap the wires or cut off the connector and butt splice (or solder if you know how) the connections. Know that there are no known accessories that plug into the accessory connectors. Except for the various add ons that members have come up with, like your LEDs, USB charging ports, etc.