Where to tap speed sensor signal?

[SportsterDoc]

For a 2014 standard, which does not have an ABS modulator, the post model year 13 schematics show a pink/green wire to position 1 in the instruments. However, tracing that wire on the schematic shows it going nowhere, whereas on the ABS models it goes to the ABS modulator with inputs from both front and rear speed sensors.

Is this your module? http://www.signaldynamics.com/brakehold

The referenced schematics are pages 20-4 and 20-5 of the FSM. I have only a merged scan of those two pages and there may be something missing.

Until you have better info, I would probe the pink/green (position 1 of 10 pin connector) for a 0-5 vdc signal with the bike on the center stand, motor running and in gear. Expect the signal to vary as the speed changes.