(12-01-2017, 10:49 PM)Gumby 1100_imp Wrote: (12-01-2017, 02:33 AM)okredneck_imp Wrote: I received my K factory pipes and they will not mount up to the exhaust ports I can get 3 of the 4 matched up but not all 4
OK,
Is one of the pipes physically not reaching or not centered over the exhaust port?
If that is the case, perhaps your header got damaged (bent) in transit.
Did you try rotating one or more of the flange plates. They are not symmetrical and each one must be oriented correctly to fit and for the studs to align.
OK,
Is one of the pipes physically not reaching or not centered over the exhaust port?
If that is the case, perhaps your header got damaged (bent) in transit.
Did you try rotating one or more of the flange plates. They are not symmetrical and each one must be oriented correctly to fit and for the studs to align.
Tried rotating the flanges and still no joy don't see that it was bent but was wondering if anyone had the same problem.