Motogear Titanium Header and TSR Air Funnel

[HondaJon_imp]

Don't need the tool to remove the O2 sensor if I go with a Motorgear exhaust, right? Did you pull your O2 sensor wires from your bike after the PCV install or leave them in place?

Correct, you can just leave it in the stock header, but you will need a plug for the sensor bung in the mototgear collector. I'm not sure what thread size it is exactly. I found a bolt in my spare parts bin that fit. And yes, I left the o2 sensor wire on the bike until I changed the header. It's routed really good and won't go anywhere.

As for the spring puller, this is the one I used;

http://www.motionpro.com/motorcycle/partno/08-0065/