Adding an oil pressure gauge

[Lord Popgun]

Max, that oil routing diagram is in the service manual. I’ll go take a look at it. It is in section 4.

It actually shows that we have 2 oil pumps in one. The Cooler Pump sends oil to the oil cooler (go figure ) and spark plugs, and the Feed Pump whose output goes to the oil filter. The EOP switch is mounted at the end of the oil filter output and after 2 tees that send oil to the the rest of the engine.

The EOT switch is mounted on the output line of the spark plug output ( or, the path is sump to oil cooler to spark plugs to the sump. EOT is between the spark plugs and sump.

In looking at the bike, there are a few gallery plugs that could possible be used, but I don’t know. Unless someone knows, I would think you might need a service manual to look at the oil flow diagram and crankcase, etc. sections to figure it all out.

Wisco, we cannot post copyrighted material. If you would like to see the flow diagram, PM me.